Home  Cyclingnews TV   News  Tech   Features   Road   MTB   BMX   Cyclo-cross   Track    Photos    Fitness    Letters   Search   Forum  

Recently on Cyclingnews.com


Giro finale
Photo ©: Bettini


Tech Feature: Trek revamps mountain bike lineup for 2007; July 7, 2006

Drawing on the past while looking to the future

Trek has spent the better part of the last decade pouring the bulk of its development resources behind the Lance Armstrong machine. Now that the party is over, some much-needed attention has been redirected to its relatively neglected mountain bike lineup. James Huang heads out to Fruita and Crested Butte, CO, to see what the giant from Waterloo has in store for the upcoming months.

The new Gary Fisher HiFi
Photo ©: James Huang
(Click for larger image)
Gary Fisher continues to support the 29er
Photo ©: James Huang
(Click for larger image)
Mr. Trek made it out on the trail
Photo ©: James Huang
(Click for larger image)
A quick transfer over to Crested Butte
Photo ©: James Huang
(Click for larger image)
Remember this?
Photo ©: James Huang
(Click for larger image)
Er…
Photo ©: James Huang
(Click for larger image)
Widely spaced oversized main pivot bearings
Photo ©: James Huang
(Click for larger image)
Even the clean downtube gusset
Photo ©: James Huang
(Click for larger image)
Gary Fisher worked closely
Photo ©: James Huang
(Click for larger image)
CNC machines make a comeback for ’07?
Photo ©: James Huang
(Click for larger image)
No head tube gusset required
Photo ©: James Huang
(Click for larger image)
Dropout pivots
Photo ©: James Huang
(Click for larger image)
Fox Racing Shox’s wares
Photo ©: James Huang
(Click for larger image)
The bottom end of the Fuel EX
Photo ©: James Huang
(Click for larger image)
The top tube decal
Photo ©: James Huang
(Click for larger image)
Now this is what I call a roof rack.
Photo ©: James Huang
(Click for larger image)

For the most part, Trek's mountain bike introduction was staffed by the usual cast of characters: an assortment of product and development crew, public honchos Gary Fisher and Zapata Espinoza, as well as a variety of its professional riders, including regional pros Nick Martin (www.ridewithnickmartin.com) and Ross Schell as well as long-time team member Travis Brown, who is now heavily involved in Trek's own product development process.

However, the most significant figure on hand from Trek was Mr. Trek himself, company president John Burke. Burke's presence at the event sent a clear signal as to how important it is for Trek to regain its position in the mountain bike world. In his own words, "We've grown our business a lot in the last five years in a lot of different areas, and it's elevated Trek in the marketplace. One area of business where we haven't grown is the mountain bike business, especially when you take a look at full-suspension and serious mountain bikes. It hasn't been a big part of what we were about. We've got a really good crew here and a lot of talented people, and we haven't performed to what we think we're capable of. If you take a look at what we're introducing tonight, we've gone out there and we think we're bringing out best-in-class product. This is just the start, but it shows the future direction of the company."

To Trek's credit, the company does have a rather long and storied history in mountain bike development and it clearly wanted to remind the press as such. The presentation hall was not only littered with images of past glory, but also with physical examples of prior achievements, the highlight of which was one of Gary Fisher's own RS-1 full suspension bikes complete with then-revolutionary parallelogram linkage rear suspension. Unfortunately, also on hand was the more forgettable 9500 with its pogo-sticklike T4xC rear end, but I digress…

Heritage aside, times have changed while the company's mountain bike line mostly hasn't. However, if this latest crop of introductions is any indication, the Wisconsin company may be on the right track towards regaining some of its past prominence and fulfilling its prophecy of a "banner year for Trek and Gary Fisher mountain bikes".

New frame geometry for Gary Fisher

Gary Fisher's currently available Genesis frame geometry was introduced ten years ago in 1996. It was conceived as a way to improve the high-speed stability and descending prowess of its mountain bikes while retaining good climbing performance, but some riders felt that low-speed handling ability was sacrificed in the shuffle. Since then, the Genesis philosophy has remained largely unchanged. For '07, however, Fisher product manager Aaron Mock and his team of engineers went back to the drawing board to create Genesis 2.0 in order to address the geometry's shortcomings.

Developed in conjunction with Keith Bontrager and Manitou, the new system revolves around a custom-built Manitou suspension fork that incorporates a 46mm offset, an increase of 7mm. To counterbalance the increased fork offset, Genesis 2.0 head tubes are pulled back approximately 5mm to retain roughly the same wheelbase measurement. These changes result in the same high-speed and descending characteristics as with the original Geometry setup, but the reduced trail is said to greatly enhance its low-speed turning ability with diminished "wheel flop".

For sure, 7mm doesn't sound like much but to put things in perspective, road-going Moto GP riders can allegedly distinguish just a 6 percent change in trail. In Fisher's case, 7mm equates to a relatively huge 11 percent. Manitou will supply not just one G2-specific fork, but two: a newly updated Minute as well as an all-new Relic. Both will wear prominent "Handling by Bontrager" decals as well as the G2 logo.

Gary Fisher, now in stereo surround sound

Genesis 2.0 geometry is featured on the company's brand-new HiFi, which replaces the outgoing Cake trail bike. The new bike abandons the Cake's basic single-pivot layout in favor of a modified four-bar (or "faux bar" as there are no chainstay pivots) configuration with a linkage-activated Fox air shock that provides 120mm of rear wheel travel. In spite of the additional pivots and hardware, the HiFi frame reputedly weighs only 2378g (5.24lb) in a medium size complete with shock and hardware. Hydroforming plays a key role in the HiFi's diet plan, most notably in the heavily shaped chainstays. As with the Cake, the HiFi chainstays are asymmetric with the non-driveside stay making a beeline directly from the dropout to the main pivot in order to increase rear end stiffness while dropping weight. In addition, carbon fiber is used in the seatstays to save 60g over even the old XC-specific Sugar rear end.

Cartridge bearings are used extensively throughout the frame, including two oversized units at the main pivot, four at the seatstay-located dropout pivots, and more still at the seat tube linkage. All of the bearings are also fully press-fit for maximum surface contact area and rigidity, and the main pivot bearings are spaced very widely for better support. Word is still out on whether or not Trek plans to offer a service kit to facilitate bearing replacement in the new press-fit setups but dealers are likely to clamor for one.

Race Day now available in 29er flavors, Fat Possum now becomes just "pleasantly plump"

Jeremy Horgan-Kobelski's signature Race Day short-travel XC race-specific platform, first officially shown at this year's Sea Otter Classic, is now in full production with three different trim levels. Interestingly, the Race Day frame actually weighs just a bit more than the HiFi, with an official weight of 2406g (5.3lb)for a medium frame complete with paint and shock.

Gary Fisher continues to demonstrate its commitment to the 29er market with two 29in-wheeled Race Day variants that share the same basic attributes as the standard Race Day: 80mm of firm, single pivot travel with elevated stays, as well as a low forward pivot and narrower 68mm bottom bracket shell that facilitates a 2x9 setup.

At the other end of the spectrum, Fisher's all-mountain 150mm travel Fat Possum hasn't gone ignored in all of the XC and trail bike hoopla. The new '07 frame drops 150g from its already fairly lean profile, mostly resulting from the switch to an inline rear shock. The new chassis hits the scales at an impressive 3150g (6.94lb) for a completely painted medium frame with shock.

In part 2, we look at the upgraded Fuel bikes, Bontrager's new rims and how it all works on the trail.

Photography

For a thumbnail gallery of these images, click here

Images by James Huang/Cyclingnews